WATERCO ZeoPlus Red Zeolite Media For Water Purifier 25kg

Packaging: 25kg/bag
Product of Australia ??

?Zeolites are minerals that contain mainly aluminum and silicon compounds. They are used as drying agents, in detergents, and in water and air purifiers.

ZeoPlus is a naturally occurring mineral rock, found in areas where there has been historic volcanic activity. Its microporous structure and ammonia removal properties will significantly improve the quality of your water

Zeolite filtration media can be used to replace sand in any sand filter. Zeolite is a high performance media allows the same filtration standards of Diatomaceous Earth (DE) with the convenience of sand. Other than that, ZeoPlus is an advanced filter media that is recommended to use with Waterco Micron W Series Filter.

?REGENERATION OF ZEOPLUS
ZeoPlus should be regenerated once it is saturated i.e. full of ammonium. On an average pool this takes around 12 months, although heavily used spas and hydrotherapy pools may require regeneration sooner. It should be regenerated once ammonium level starts to increase. As a rule of thumb, regenerate it when the ammonium concentration of the outlet water is greater than 1 ppm.

?REGENERATION PROCEDURE:
?Backwash the filter as usual until the backwash wastewater is clear of particulates
?Isolate the filter
?Drain completely the water in the filter by opening the bottom drain plug and replace drain plug once finished
?Make up 200g/L of brine solution. Refer to example below to determine the required amounts of salt and water
?Pour the well dissolved brine solution into the filter until it completely covers the bed by about 40mm
?Mix solution into the media by agitating vigorously. Replace lid or MPV
?Leave it to soak overnight (for a minimum period of 12 hours). Once regeneration is complete the ZeoPlus bed must be rinsed with fresh water until the outlet water salt level or TDS is similar to the incoming water
?Turn the valve(s) to BACKWASH cycle. Run BACKWASH for 3 to 5 mins
?Run RINSE cycle for 3 minutes then select BACKWASH again, followed by RINSE for another 3 minutes. If the filter does not have a RINSE cycle, run BACKWASH for an extra 20 minutes
?Turn valve(s) to FILTER cycle. You are now ready to operate the ZeoPlus filter as

??NOTE:
Always turn off the pump before changing valve position.
In heavily used spas and hydrotherapy pools, regeneration may be required sooner than 12 months.

?FEATURES:
Zeolite turns any sand filter into a super filter. Using an all-natural zeolite mineral, ZeoPlus as a media provides many valuable advantages over ordinary sand media.

Superior water clarity, Ammonia removal, Dual filtration, Reduced chlorine demand, Reduced skin and eye irritations, Reduced odour